Tips for designing with only two copper layers on a PCB (layer assignment, component placement, routing, GND jumps, RF considerations). PCBs by PCBWay https://www.pcbway.com
[SUPPORT]
Hardware design courses: https://phils-lab-shop.fedevel.education
Course content: https://www.phils-lab.net/courses
Patreon: https://www.patreon.com/phils94
Free trial of Altium Designer: https://www.altium.com/yt/philslab
Altium 365: https://www.altium.com/altium-365
[GIT]
https://www.github.com/pms67
[SOCIAL]
https://www.instagram.com/philslabyt
[LINKS]
Stitching Vias Article: https://resources.altium.com/p/everything-you-need-know-about-stitching-vias
2- vs 4-Layer EMC Video: https://www.youtube.com/watch?v=crs_QLuUTyQ
[TIMESTAMPS]
00:00 Introduction
02:01 PCBWay
02:41 Altium Designer Free Trial
03:33 Why 2 Layers?
05:54 Design Constraints
08:34 Layer Assignment & Board Thickness
11:24 Component Placement
14:40 Routing Order, Power Routing
16:49 Signal Routing, GND Jumps/Pours/Stitching
23:06 RF & Controlled Impedance
28:54 2- vs 4-Layer PCB Considerations
31:23 Outro