Find all our Alaskan Mills and Chainsaw accessories at granberg.com
Learn from Mr. Erik Granberg, President of Granberg International the tips and tricks to getting the best results from your Alaskan Chainsaw Mill.
*VIDEO RECAP*
1. THREE important things to consider before milling. One, does your chainsaw have enough power? (see bar/power reference chart). Two, ripping chain is necessary! Three, a first cut system to assist in your first cut. (0:35)
2. Inspect log and debark. Check diameter of log vs the cutting width of mill. Is your mill going to make it through the cut? There may be a section that is too wide. This can be trimmed before milling. (2:00)
3. Mount Alaskan Mill onto bar. Adjust to fit bar. Avoid clamping down on the sprocket nose. Tighten all hardware. The clamping bolts for the bar and end bracket require 10-12 pounds of torque. Tighten evenly. All other carriage bolts use 8-10 pounds of tightening torque. Do not over tighten, this only weakens the bolts. (3:15)
4. Tool kit check. (11:07)
5. Safety Equipment. Chaps, gloves, boots, eye and ear protection are required! (11:51)
6. Make sure your wedges are handy! (12:20)
7. Best way to start your second cut. (13:17)
8. Wedging tips while milling. (14:18)
9. What to look, listen and feel for while milling. (14:54)
10. How to exit the cut. To keep the mill from dipping when exiting cut, put a little back pressure on upright handle and support the powerhead. (17:24)
-------------------------------------------------------------------------------------
Visit us: https://www.granberg.com
Follow us on Instagram: https://www.instagram.com/granberginternational/
Follow us on Facebook: https://www.facebook.com/granberginternational/
Join in us in our Facebook group: https://www.facebook.com/groups/309929076121237