A step by step tutorial for building Box Jaw Tongs. I like to use these for holding wide flat stock (like a rasp) securely in place.
Check out my list below of the tools and materials I used to make these.
Tools & Materials I used in this video:
- 3/4” x 8” Sucker Rod
- Round Stock Tongs: https://youtu.be/a3YKm77zdsM
- 1909 Lakeside Anvil
- 10lb Short Handled Sledge
- Power Hammer
- 1.75lb Bulldog Rounding Hammer
- 3/8” Flat Jaw Tongs: https://www.youtube.com/watch?v=c0_QD5ZBO0o
- Hot Punch: https://youtu.be/EBIYsESxxTo
-Rivets: https://amzn.to/3KPL1VG
-Beeswax: https://amzn.to/3AiCrdd
Disclaimer: I only recommend products I use myself and all opinions expressed here are my own. This post may contain what are referred to as “affiliate links.” If you click on a link that brings you to a page where you may like to purchase something, your shopping experience will not be at all affected. However, I may receive a small commission at no additional cost to you. Thank you so much for supporting this channel!
Hi, I'm Jayce, the blacksmith behind Farmstead Forge. I am a farrier by trade; I learned the basics of blacksmithing at shoeing school and the rest I learned on my own. I'm excited to expand my knowledge and continue learning while also sharing my passion with others.
Join me in the shop on my Montana farmstead where I enjoy building tools and other fun projects that we can use around the place.
If you enjoyed this video please consider giving it a like, I’d appreciate it! Also, make sure to subscribe so you don’t miss out on new videos every Tuesday morning!
Contact Me: [email protected]
00:00 Introduction
02:12 Upsetting the short jaw
02:54 Setting first jaw
04:40 Setting first boss
06:16 Setting the rein
07:29 Upsetting the second jaw
08:53 Setting the second jaw
10:20 Setting the second boss
12:29 Drawing out the rein
15:46 Refining the boss and jaw
17:34 Punching the rivet hole
20:28 Forging the box jaw
25:29 Hot rasp
26:10 Touch mark & riveting
26:56 Sizing
30:36 Finished Product
31:04 Outro