Build a CNC Controller with Arduino, TB6600 and GRBL

How to configure a new CNC? After building the C-Beam CNC which I got as a mechanical build from a Chinese maker it was time to start with the electronics. It took me a while to understand what components are required and how I should go about it. Because all these details were not available at one place I have decided to write this post in detail to explain them. Hope you enjoy it. ------------------//------------------ Written Tutorial: https://goo.gl/FvU1za Download the schematic: https://goo.gl/akvbUe ------------------//------------------ REQUIRED MATERIALS: Stepper Motor: https://goo.gl/Qsu2Ba TB6600 Stepper Motor Driver: https://goo.gl/rryycT Arduino Uno: https://goo.gl/in5QcH Power Supply: https://goo.gl/3xigZV Emergency Stop Switch: https://goo.gl/b9Et5V Router & Power Switch: https://goo.gl/xtFt76 4 Pin Connectors: https://goo.gl/qcmXqr AC Power Connector: https://goo.gl/B2KnEJ C-Beam CNC Mechanical Build: https://goo.gl/qfn2FJ ------------------//------------------ VIDEOS: Finding stepper motor wires: https://goo.gl/iBiiGv GRBL: https://goo.gl/fFQTRQ Universal Gcode Sender: https://goo.gl/UemxUu Easel: https://goo.gl/85hcPG ------------------//------------------ FOLLOW ME ON: http://instagram.com/kalaakaar.in http://facebook.com/kalaakaar.in http://twitter.com/mr_jcrp ------------------//------------------ MORE PROJECTS TUTORIALS and POSTS http://www.kalaakaar.in/builds ------------------//------------------ MUSIC: Bit Quest (incompetech.com) ------------------//------------------