Hey y'all! After buying an Iron City post vise about six months ago I finally built a proper stand for it. My woodworking skills were definitely rusty, but I'm always glad to get my hands dirty in the shop!
I have the materiel list for this build below if you're interested in that!
6x6 (pressure treated)
-8ft total
4x4 (pressure treated)
-30ft total
8in long lag screws
-14 EA
6in long lag screws
-24 EA
Washers
-At least 38 EA
**The diameter of the lag screws don't really matter. But make sure you have the right size drill bit for the recommended pilot hole! I was using a smaller drill bit, and it made driving them in much harder than it should have been.
Check out our other pages!
Facebook: https://www.facebook.com/BloodMountainBoys/
Instagram: https://www.instagram.com/blood_mountain_boys/