I wanted to test the top three wipers to see if any of them can finally rid the X1C printer of the pooping problems that have been plaguing it since the first time I tried printing with PETG.
Help support this channel! https://www.patreon.com/Needitmakeit
The simple solution is to stop printing with PETG, but there are some valuable properties that PETG has the other filaments don't so I'd prefer to find a solution. The newest printers have a system to fling the poop away, sending it all over the place, this printer uses a wipe and chute setup, which works well for PLA and ABS, but try it with PETG and you'll find that it struggles quite a bit.
We'll look at why it has problems and we'll run some torture testing to see if any of the wipers have what it takes to rid the printer of this problem once and for all.
TechNerd: https://makerworld.com/en/models/529681#profileId-446757
Maleko: https://makerworld.com/en/models/529681#profileId-446757
Thank you for helping to make this channel a success! Affiliate links:
**QIDI PLUS4** - https://qidi3d.com/products/plus4-3d-printer?sca_ref=5735403.eknTRISP1e
Early Bird - A choice of either a Tungsten Carbide Bimetal Nozzle or a Bimetal Hot End (Shipping begins in 2 months for these)
Possible Coupon - 30DAYSGIFT
Possible Coupon - HIGH5
**Thermal Master P2** - https://shrsl.com/4o6j1
Coupon Code 8% Off for my viewers
QIDI Q1 Pro - https://qidi3d.com/products/q1-pro?sca_ref=5735403.eknTRISP1e
Bambu X1C - https://shrsl.com/4j1gz
Bambu Filament Shown in Videos - https://shrsl.com/4ks0j
Creality HF PLA Filament - https://shrsl.com/4p9ag
Panda Jet For Bambu P1 and X1 Series (Tested and proven to work well) - https://shrsl.com/4jhht
Creality PI (Single) - https://amzn.to/3Xo3jUC
Creality PI (Double) - https://amzn.to/3XdQ4pj
Rode Mic - https://amzn.to/3vcMKAr - https://amzn.to/3NBFvZe
#bambu
#x1carbon
#3dprinting