What you will need:
Computer & printer
A4 paper
Laminator and laminator pouches
Paper cutter / guillotine
Scissors
Wide clear packing tape (about 5cm wide)
Single hole punch
Plastic coated coat hangers with at least a 30cm width
• 22 for solids
• 1 for variegated
• 3 for colour variations
• 2 for light effects
• 3 for satins
• 31 TOTAL
Hinged craft rings – 32mm (1 1/4 inch) or 25mm (1 inch) I found mine on eBay, they are also called scrapbook rings and binder split rings.
• 18 for variegated
• 470 for solids
• 59 for colour variations
• 40 for Light effects
• 60 for satins
• 647 TOTAL
And of course DMC floss!
1. Print out PDF from the Facebook group Stitch Maynia (https://www.facebook.com/groups/712411758884598/) in the files section. You must be a member of the group to view the file. I have formatted these for A4 paper.
2. Cut each into strips leaving enough room BELOW the DMC numbers to punch a hole so at least 2cm (about ¾ inch). My strips were approximately 4 cm (1 3/4 inches) high give or take.
3. Place these strips into laminator pouches as shown and laminate
4. Cut out these laminated strips of card leaving about 5mm (1/8 inch) around
5. Using a single hole punch place a hole below each DMC number making sure they are not touching
6. Place your coat hanger on a flat surface and put the laminated card in the centre of the cross bar
7. Using one piece of clear packing tape (5cm or almost 2 inches wide) attach the laminated card to the coat hanger
8. Now attach your DMC! Using a hinged craft ring loop through the top of your floss skein and through the punched hole in the card.
9. Hang and enjoy!
Stitch Maynia Facebook Group https://www.facebook.com/groups/712411758884598/
DMC Shopper's Checklist http://www.dmc-usa.com/Conversion-Charts.aspx