Sometimes your project vehicle might seem daunting, but you just need to chip away at it. Today I'm doing a fun easy fabrication job on the old mangled front bumper of this 1946 Willys Jeep CJ2A. Even though there are bigger problems that need addressed, this was a good repair that I could start and finish in a day. This jeep lived on a farm or vineyard for a long time, so it has been used, abused, butchered and ignored. This new bumper mod will make it one step closer to trail ready.
All of my welders and plasma cutters are from Miller Electric.
https://www.millerwelds.com/equipment/welders/mig-gmaw
https://www.millerwelds.com/equipment/plasma-cutters