I'll show you step by step how I made my bent shaft paddle for around $20. You only need about 1 piece of 10 foot long 2x4 board for the whole job! Tools needed are:
Belt Sander
Table Saw
Palm Sander
Angle Finder (protractor)
4 - 6 wood clamps
Bench
Planer (I had electric but I like manual better)
#canoe #canoeing #paddle #canoepaddle #makeyourownpaddle #DIYpaddle #outdoors #wildernesscanoe #familycanoe
See the more detailed blog post with photos and instructions for the DIY option at:
ruggedoutdoorsguide.com
TIMESTAMPS
0:00 - Start / intro
01:31 - First step in the process
13:31- Final step in the process
14:10 - Extro/ending
Blog: https://ruggedoutdoorsguide.com
My CAMERA AND VIDEO PRODUCTION GEAR:
○ My camera - https://amzn.to/3xyRTi8
○ SD card - https://amzn.to/39G6aP1
○ Tripod - https://amzn.to/2SWsT3d
○ Studio lights - https://amzn.to/3xwp4CM
○ Green Screen - https://amzn.to/2SVqJkq
○ Microphone - https://amzn.to/3gIoWL9
And make sure you subscribe to my channel!
DISCLAIMER: Links included in this description might be affiliate links. If you purchase a product or service with the links that I provide I may receive a small commission. There is no additional charge to you! Thank you for supporting RuggedOutdoorsGuide.com so I can continue to provide you with free content each week!