OK Part 3 of this CNC plasma Cutter build series.
In todays episode I
- Wire up the electronics
- Explain the issue I had with me ESP32 controller
_-Install the x and Y axis cable chains
- Run all the shielded cables
- Power up the control box
- Test the stepper motor drivers using the Rotary axis drive, also explain the rotary axis belt configuration
- Water pan arrived so I slid it into position
- I explain some more opportunities to improve the original JD's Garage plans to make your plasma cutter better/larger cutting area without you paying any more.
Hope you enjoy the content.
Sully