🛠 DIY: How to replace a fuse/relay box with a PDM | TECHNICALLY SPEAKING

#haltech #pd16 #wiring Rewiring and re-pinning a Fuse/Relay Box directly into a Haltech PD16 sounds like a daunting task - but it isn't. Here is step-by-step guide to removing a fuse box from your harness and re-wiring it into a PDM. --------------------------------------------------------- Products used in this video: PD16 and Accessories: https://www.haltech.com/product-category/inputs-and-can-expansion-products/power-management/ Dual Crimper Set: https://www.haltech.com/product/ht-070300-dual-crimper-set/ Crimping tools: https://www.haltech.com/product-category/tuning-tools/ CAN adaptor loom: https://www.haltech.com/product/ht-130046-can-adaptor-loom/ ----------------------------------------­---------------- Don't miss out on our next video - subscribe to our channel. ----------------------------------------­---------------- For more Haltech goodness check out our: Website: www.haltech.com Facebook: https://www.facebook.com/HaltechEngineManagement Instagram: https://www.instagram.com/haltechecu ----------------------------------------­---------------- 00:00 Introduction 02:08 what we are working with 02:39 where to cut 06:12 assigning the wires 09:01 Pinning the DTP connector 13:08 Pinning the main connector 19:34 leftover wires 20:39 grounding 23:20 CAN connection 27:39 wrap-up and final thoughts -~-~~-~~~-~~-~- WATCH NEXT: "🏅 Jason Waye's Barra Powered Fox Body | HALTECH HEROES" https://www.youtube.com/watch?v=pUAjmcAISjo -~-~~-~~~-~~-~-