Today, I’m going to be removing my FiTech EFI and installing the all new Edelbrock Pro Flo 4 EFI system.
You can get the Edelbrock Pro-Flo 4 here: https://amzn.to/2yCkAyk
The Edelbrock Pro Flo 4 Electronic fuel injection system has a great installation guide that I encourage everyone who is installing this system to look through. But the step by step of the installation is:
00:00 - Installation Introduction
01:36 - Remove throttle body and intake manifold
01:46 - Clean heads for ProFlo 4
02:51 - Install the Wide Band O2 sensor
03:25 - Test fit the Intake, Throttle Body and all wiring and harnesses
04:31 - Put a bead of RTV on intake heads
04:38 - Install Pro Flo 4 intake and throttle body
04:48 - Tighten intake bolts to around 20ftlbs
04:53 - Install Distributor
06:28 - Wire up all the wires
07:42 - Spark Plug wires
07:48 - Air Cleaner Sensor
08:09 - Fuel Pressure regulator
Now if only it were really that easy, haha!
Universal Joint Socket:
https://amzn.to/2YGi30y
Watch the Intake Manifold removal video:
https://youtu.be/vq7lfKvVm3Y
Watch the FiTech installation Video:
https://youtu.be/8_sAb-iwlz0
Watch the Fuel Pump Installation Video:
https://youtu.be/baq7LVREgmI
Extra things I needed:
- Thermostat Gasket, or RTV https://amzn.to/339HiM4
- AN fitting for return line https://amzn.to/2LZGrIM
- Relay on the Fuel Pump https://amzn.to/2KlXocT
- Fuel pressure Regulator https://amzn.to/2KfLTos
- Fuel Pump https://amzn.to/3384RoD
Thanks for watching and be sure to SUBSCRIBE so you'll have more Early Bronco video's in your inbox! 📬
👕 10% Off Shirts! Use promo code: YOUTUBE http://bit.ly/NashEB 👕
🛠 Here are some of my favorite tools 🛠
https://www.amazon.com/shop/nashvilleearlybronco
👉🏼 My steering wheel 👉🏼 https://amzn.to/2NNX4on
➡️ http://www.nashvilleearlybronco.com ⬅️
🎥 SUBSCRIBE: http://bit.ly/2l5gZA0
📷 INSTAGRAM: http://bit.ly/NEBInstagram
💻 FACEBOOK: http://bit.ly/NEBroncoFacebook
#earlybronco #classicbronco #fordbronco