EP 16 Onefinity CNC - Let's Break A CNC Machine | Hobby CNC machine CUTS at 1,250 IPM!

#needforspeed #cnc #onefinitycnc We decided we’d try to break one of our ELITE series machines by pushing it to its absolute limit, just to see what would happen - and the results are astonishing! The test was simple… We used one bit (¼” upcut spiral), running the spindle at 24,000 RPMs for the entire test. Starting at 100 inches per minute, we cut straight lines along the X-axis, increasing the feed rate incrementally to see how fast we could get this thing to cut. If you’re surprised, know that we were just as surprised as you… But not really. Onefinity CNCs were designed and built to redefine the capabilities of the “hobby CNC”, and this experiment shows just how powerful and well designed these machines are. We hit an INSANE feed rate of 1,250 inches per minute (529.17 mm/s), cutting ¼” deep across 24”. Do you know of another machine that can do that? Let us know in the comments! Bit | https://amzn.to/3VMgD3P Starbond CA Glue | https://amzn.to/42ltdcK Onefinity Elite Woodworker | https://www.onefinitycnc.com/product-page/elite-woodworker-32-x32-cut-area https://forum.onefinitycnc.com/t/ep-16-onefinity-cnc-lets-break-a-cnc-machine-hobby-cnc-machine-cuts-at-1-250-ipm/20515 ** Please note, speeds shown in this video are not factory settings. Onefinity sets the maximum feedrate to 400IPM from the factory. While we don't recommend changing any of the F1 settings, it sure is fun trying :P https://www.onefinitycnc.com https://forum.onefinitycnc.com