I've developed some bad habits with my table saw that could cost me my fingers and they mostly revolve around not having an outfeed table.
My table saw sits against the garage door and feeds out the door into the driveway, and the driveway is sloped, this makes it hard to have any sort of outfeed table.
With this design however, I am able to keep my saw in the same position and know that the outfeed table will always be level with the saw bed whenever it is extended.
Some of my tools:
Router - https://amzn.to/39B8vj2
Pocket hole jig - https://amzn.to/3DxARVG
Woodpeckers stainless steel squares - https://www.woodpeck.com/woodpeckers-stainless-steel-squares.html
Planer/Thicknesser - https://www.carbatec.co.nz/product/36507-carbatec-10-combination-planer-thicknesser-with-spiral-head?categoryId=267
Cabinet Saw - https://www.carbatec.co.nz/product/17056-carbatec-professional-250mm-cabinet-saw-with-30-t-glide-fence-kit?categoryId=289
Jig Saw - https://amzn.to/3j0Eom8
Circular Saw - https://amzn.to/3v9Nrab
Brad point bits - https://amzn.to/3K6rnmK and https://amzn.to/3x7uAie
Right angle clamps - https://amzn.to/3uP9zX8