Hello fellow YouTubers, my name is AJ, and this is Gen-Z Garage!
In this episode, I'm going to rebuild the distributor from my 2.5L Iron Duke 4 cyl. I could just buy a rebuilt one with everything already on it, but what fun would that be? Plus, I also upgrade the distributor with a heat sink to extend the life of my ignition control module!
Content Timestamps:
0:00 Introduction
0:20 Recap and Plan.
0:48 Disassembly - Cap & Rotor
0:50 Disassembly - Ignition Control Module
1:23 Disassembly - Stator Ring & Magnet
1:53 Disassembly - Removing Shaft Pin
2:30 Disassembly - Removing Distributor Shaft
2:36 Disassembly - Removing Pickup Coil
3:05 Re-Assembly Begins
3:12 Re-Assembly - Installing Pickup Coil
3:42 Re-Assembly - Installing Distributor Shaft
4:13 Re-Assembly - Gear, Spring, and Shaft-Pin
4:52 Re-Assembly - Installing Stator Ring & Magnet
5:04 Re-Assembly - Installing New O-Ring Seal
5:20 UPGRADE - Adding a Distributor Heat Sink
6:47 Re-Assembly - Installing New Cap & Rotor
7:04 Conclusion
7:17 No idea what this is...
#fiero #classiccars
#cargirl #classiccars #pontiac
@GeneralMotors