How to set the cable length with the enviolo cable tool.
00:04 - For this, you need the following tools:
2 mm Allen wrench
Cutting pliers
enviolo cable tool
00:08 - Start by turning the controller on the handlebar counterclockwise to set it to the full overdrive position.
00:16 - Guide the cables through the cable housing.
And strap the enviolo cable tool to the chainstay.
00:24 - Make sure the cable housing is fully seated in the barrel adjusters and turn both barrel adjusters completely in.
00:34 - The cable with more length is the underdrive cable.
00:39 - Slide the cable through the underdrive cable stop.
00:45 - Place the cable housing and cable stop in the enviolo cable tool multi-turn position.
Slightly pull the cable and tighten the cable stop screw to 1.5 to 2 Newton meters.
00:58 - Now take the overdrive cable and slide it through the overdrive cable latch.
Place it in the enviolo cable tool, slightly pull the cable and tighten the cable latch screw to 1.5 to 2 Newton meters.
01:14 - After removing the enviolo cable tool, please cut the underdrive cable as short as possible and the overdrive cable at the mark and tuck the remaining cable length in the pocket underneath.
01:30 - Learn more about the cable length with the enviolo cable tool at https://support.enviolo.com