In this short video, you will be introduced to how to use Punch Down Tool properly. Only eight steps, but each step is detailed and clear.
Related products:
🔥VCELINK Punch Down Tool Kit
👉https://bit.ly/3XugYLe
🔥Cat6 keystone jack:
👉https://bit.ly/4ba4BaC
🔥Punch Down Tool:
👉https://bit.ly/3xrt0KY
🔥Punch Down Stand:
👉https://bit.ly/4b8pNO1
🔥Mini Wire Stripper:
👉https://bit.ly/4evrszZ
---------------------------------Steps--------------------------------------
1. Pull down the neck collar on the tool
2. Cut off the outer of the ethernet cable
3. Clean plastic strip
4. Separate wires and make them straight
5. Place wires in the right orders
6. Insert wires into the plug
7. Punch down the impact tool
8. Put a cap on the plug and then connect the plug to a wall plate
Done!!!!!!!!!!!!!
FOLLOW US:
👉Facebook: https://www.facebook.com/VCELINKofficial
👉Ins: https://www.instagram.com/vcelink_official/
👉Twitter: https://twitter.com/vcelink
👉TikTok: https://www.tiktok.com/@vcelinkofficial
Check out our shop!
► https://www.vcelink.com
#punchdown #ethernetcable #rj45 #punchdowntool #diy #network #keystonejack #VCELINK
If you have any questions or concerns, please feel free to make a comment below!
If you think it's a helpful tutorial, please LIKE and SUBSCRIBE to us!
😍Thanks for watching, see you next time!
▼What else is Worth Watching?▼
How to Install CAT6 pass-through connector？
https://www.youtube.com/watch?v=owZyo2r5IwA&t=0s
How to Use Punch Down Tool?
https://www.youtube.com/watch?v=SE54ILAoerQ
How To Terminate CAT 7 Category Cables？
https://www.youtube.com/watch?v=yOgOhCs5EvQ
The Most Detailed Brush Wall Plate Installation Tutorial |VCELINK
https://www.youtube.com/watch?v=y_MrNlRpTZc&t=0s
How to Punch Down an RJ45 Cat6 Keystone Jack VCELINK?
https://www.youtube.com/watch?v=OFqFaNZsjsU