You will learn how to convert steady-state simulation to dynamic simulation. How to introduce different controllers and how to enter controller tunning parameters. You will also see the interaction between setpoints and process variables. Also, you will learn about direct action control and reverse action control strategies.
📢 If you find my content helpful, please don't forget to subscribe to my channel https://bit.ly/3b6wuV9 🔔.
If you want ❤️ to learn Aspen HYSYS from very basic, then check the following links:
Tutorial # 1
Getting started with Aspen HYSYS
https://www.youtube.com/watch?v=PIlFfN04d5c&t=3s
Tutorial # 2
Bubble point, Dew point and Phase diagram calculations
https://www.youtube.com/watch?v=51xsH4Ejpd8&t=39s
Tutorial # 3
Flash calculations in HYSYS
https://www.youtube.com/watch?v=XfOVKGr0fp0&t=24s
Tutorial # 4
Sensible and latent heat and generation of saturated steam table in Aspen HYSYS
https://www.youtube.com/watch?v=d156FmGmUZk&t=63s?sub_confirmation=1
Tutorial # 5
Centrifugal pump sizing and selection in six easy steps
https://youtu.be/fL1M77QVPHE
Tutorial # 6
Pump power and efficiency calculations in HYSYS
https://youtu.be/ppj-xhOdiCQ
Tutorial # 7
Pump performance curves generation and rating in HYSYS
https://www.youtube.com/watch?v=6H3gVMHPnM0&t=208s
Tutorial # 8
Simulation of Compressor and Turbine in Aspen HYSYS
https://youtu.be/7F8l48W__mI
Tutorial # 9
Compressor Surge Analysis in Aspen HYSYS
https://www.youtube.com/watch?v=ssB3qbXdHhY&t=144s
Tutorial # 10
Pipe Sizing, Pressure Drop Calculation, Use of Adjust Function in HYSYS
https://www.youtube.com/watch?v=2nBuwyHhsSE&t=332s
Tutorial # 11
How to use case study tool and generate vapor pressure curve for Propane in HYSYS.
https://www.youtube.com/watch?v=d5FCOcCb7NE&t=13s
Tutorial # 12
Crude oil three phase separation | Decanter simulation in HYSYS
https://www.youtube.com/watch?v=WK0mv_DCN6c
#DynamicSimulation #HysysDynamic #LevelController #FlowController