Part available on Amazon: http://amzn.to/2q7HEON
The Motor Driven Power Steering, or MDPS, Coupler is a common failure for these vehicles. It causes a clunking noise while steering. It is a simple rubber coupler that gets shredded over time. This specific car had 75,000 miles on it when it failed. We'll show you how to replace it.
MDPS Rubber Coupler: http://amzn.to/1IH2X1N
이제 한국어 자막을 사용하실 수 있습니다.
자막 버튼을 누르신 후 설정에서 원하시는 언어를 선택해주시기 바랍니다.
00:00 - Intro
01:42 - Remove Covers, Bolts Behind Steering Wheel, Re-Center Steering, and Then Disconnect Battery
02:20 - Remove Metal Shield
02:48 - Remove AC Duct
03:30 - Loosen Steering Column
04:20 - Disconnect Plugs and Mounts and Lower the Steering Column
08:52 - Unbolt Computer from Motor
10:40 - Remove Bracket Plate
12:08 - Remove Computer from Motor
12:32 - Unbolt Motor
12:55 - (Optional) Disconnect Steering Shaft
13:55 - Remove Motor
15:01 - Remove Debris
17:04 - Install New Part
18:06 - Connect Motor
20:56 - Bolt Motor
21:27 - Install Computer
22:02 - Install Bracket Plate
23:55 - (Optional) Install Steering Shaft
24:31 - Bolt Steering Column Back Up
26:00 - Connect Plugs and Mounts
26:34 - Connect Battery, Start Engine, Verify Repair
27:18 - Install AC Duct, Metal Shield, and Covers
28:21 - Final Thoughts