G'day everyone,
In this video I will be making a set of matched V blocks. It is a project that I have been meaning to get around to for quite some time, but due to a lack of time and the inability to get steel in the correct size and grade, it has been a project that I have never gotten around to doing.... until now. Because I am starting out with a piece of 300 grade low carbon steel, I will have to case harden it before I heat treat it.
#machining #heattreatment #diy
Timestamps
0:00 - Introduction
0:53 - Facing The Stock
2:12 - Cutting The V Groove
5:05 - Cutting The Slot and Cutting It In Half
6:38 - Testing On The Surface Plate
7:23 - Case Hardening The V Blocks
13:03 - Grinding the V Blocks
15:07 - Making The Clamp