The video shows how a toothed pulley was cast and then machined.
The pulley is to go on my spin indexer which will be connected with a toothed belt drive to an Arduino controlled stepper motor.
This will enable any number of divisions to be indexed at the touch of a button.
The electronics and Arduino sketch were devised by Gary liming and can be seen here. http://liming.org/millindex/
Details were also given in Model Engineers workshop issue 249.
Arduino and LCD shield https://goo.gl/s7R4Zz
Motor driver https://goo.gl/Fh72ie
Stepper motor
https://www.omc-stepperonline.com/nema-23-bipolar-1-8deg-1-9nm-269oz-in-2-8a-3-2v-57x57x76mm-4-wires-23hs30-2804s?tracking=5aaf0b2bd216e