In this video, I go over in detail how I program a Digitrax DH123 DCC decoder, using a DT602 throttle on a Digitrax system.
I will program the 4 digit address on the programming track, which is wired to the programming track outputs on our DCS100 command station.
Once finished with that, I move the engine over to the main line and show you how to adjust the start and max voltage, and add momentum.
Towards the end I briefly discuss the Quick Decoder Setup utility built into the 602 throttle which might make it easier to program 4 digit addresses and make changes to CV29.
0:00 Introduction
1:10 Changing to a 4 digit address on the Programming Track
9:11 Programming on the Main
19:20 Quick Decoder Setup utility
22:28 Closing Remarks
Thanks for Watching!