Raspberry Pi 5 installed in Argon One V5 case

This video will chronicle my adventure of installing a Raspberry Pi 5 (16 GB RAM) into Argon40's new flagship case: the Argon One V5. I will also install the NVMe board which is an optional accessory. To install Argon One V5 software, in terminal, type this: sudo nano /boot/firmware/config.txt near the end of that file, add this: dtoverlay=dwc2, dr_mode=host (It may already be there) Next, in terminal, type: curl https://download.argon40.com/argon1v5.sh | bash Hit "Enter" key reboot Corrections: 5:25 The NVMe board did not "ship" separately, but was ordered as an optional accessory. The case can be used without it, and it can be added later, if desired. 6:52 As viewer attilaborzak7557 noticed, one of the thermal pads was incorrectly placed on the WiFi chip instead of the PMIC. I have disassembled (again) to correct this issue. Thank you attilaborzak!!