If one cylinder rod to repair wasn't enough today we have THREE to be repaired! In this video we are repairing three dozer hydraulic cylinder rods, they all have damage to the chrome and so the rods need to be replaced. We have two Ripper Tilt cylinder rods for a D10R dozer and one Ripper Lift rod for a D6R dozer. This shows the step by step process to remove the eyes off the old cylinders, make the new rods and then tack and weld the eyes onto the new cylinder rods. First we use the lathe to machine the eye off the rod and then machine up the new cylinder rods using induction hardened chrome bar. We need to machine both ends of the cylinder rod, the first end we machine and cut the external thread to suit the piston & nut. We then machine a spigot on the other end of the rod to fit the eye and a taper for weld prep before fitting and tack welding the eye in position. The eye is welded on using dual shield wire. We finish the job by cleaning, wrapping and strapping the rods and send them back to the customer.
In this video we are using:
- TM-26120G Centre Lathe
- WIA 500i Weldmatic welder
- Weldmac WHP-2.5 Power tilt positioner
Join our channel:
We upload new videos every Friday at 5pm AEST! If you want to see more of our videos click LIKE & SUBSCRIBE! You can subscribe to our channel here: https://bit.ly/ceesubscribe
Join our Patreon community: https://www.patreon.com/cuttingedgeengineering
To see more follow us on online here:
Instagram https://instagram.com/cutting_edge_engineering
Facebook https://www.facebook.com/cuttingedgeengineeringaustralia/
Official CEE Merch shop: https://www.ceeshop.com.au
Check out our AMAZON store and explore our favourite finds that we use in the workshop:
https://www.amazon.com/shop/cuttingedgeengineeringaustralia
About Us:
Our channel is all about showing you real life machining work from our workshop on the Gold Coast Australia. We specialize in manual machining, hydraulic repairs and heavy fabrication for the earth moving, mining and civil construction industries. So if you're a machinist that wants to see some big gear in action be sure to subscribe to our channel right now. We upload new videos every week that show lathe machining, milling, welding and all the good stuff that comes from a machining workshop. If that sounds like something that you would enjoy seeing, then make sure to join us by subscribing!
Music: https://www.epidemicsound.com/referral/rccrvr/
Song: Draw lines in the sand by Blood Red Sun
#australianmachinist #machineshop #machinist