[DIY] The self-made table saw has been completed. I made it by thinking about the lifting system, the angle system, and so on! !!
but,,,
At the time of angle cutting, I was particular about sticking out the blade from the same place as at right angle cutting, but it seems that I lowered the axis too much, so it ended in failure 😂
It's not that you can't cut the angle, so I'll fix it later! !!
Now that the table saw is complete, I would like to make a jig for the table saw and make it convenient 😊
[Video table of contents]
0:00 Completion
0:10 Switch installation
1:03 Table processing
6:42 Split blade mounting (safety measures)
8:18 Dynoc film pasted
8:38 T slot installation
9:07 Trial cut
10:03 Reflection
10:15 Completion
Referenced video
https://youtu.be/pkn_fhdT_ic
https://youtu.be/YFeSXQ1YovM
https://youtu.be/Lagcm4Y9j6c
https://youtu.be/XEkejMmxzmk
#Self-made #tablesaw #tablesaw #diy