In this video, I unbox and review an electronics bench power supply, the NANKADF WPS3010H Programmable DC Power supply, along with a USB power monitor.
I open it up, look at the controls and the manual, then bring it to the desk and test drive it with a robot and interact with its settings.
Chapters:
00:00:00 Introduction and WPS3010H power supply unboxing
00:01:09 Power supply cables shipped with WPS3010H
00:01:36 Close up view of the back of the WPS3010H bench power supply
00:02:28 WPS3010H Bench power supply front panel controls
00:02:56 Looking through the WPS3010H bench power supply manual
00:07:36 Getting the power supply powered up on the desk
00:08:20 WPS3010H bench power supply settings - turning the beeper off
00:09:19 Setting the voltage on the WPS3010H bench power supply
00:11:03 Attaching the WPS3010H bench power supply test leads
00:12:02 Testing the WPS3010H bench power supply with a robot
00:13:47 Taking a look at the Makerhawk USB Type-C tester instructions
00:15:35 Testing the Makerhawk USB Type-C tester in a USB extension dock
00:16:21 Turning on the Makerhawk USB C-Type tester in a laptop USB port
00:18:01 Closing thoughts on the bench power supply and USB tester
Products in this video:
- Makerhawk USB C-Type tester - https://amzn.to/3upJFtP
- WPS3010H DC bench power supply https://amzn.to/3721uXg