Conduit Bending: Parallel Offsets, How to calculate and implement Parallel Adjustment Constants.

In this video I show you how to find the parallel adjustment constants and how to implement them in your offsets to create equal spacing throughout all of your conduits. I also give you a quick offset bending example, even though the video is not about how to bend an offset. I threw it in anyway.
Reminder:
Just want to take the time out to stress that when you take your measurement to calculate parallel adjustment, you MUST TAKE THE MEASUREMENT FROM CENTER TO CENTER OF THE CONDUITS YOU ARE BENDING THE OFFSETS FOR. It will not work otherwise. Also it doesn't matter if you are doing horizontal parallel offsets or vertical offsets, so long as you get the center to center measurements from the conduits it will come out just fine.
I posted all the Parallel Adjustment Constants in the video, you should either write them down or take a screen shot and keep them on you. After watching this video there should be no reason why you don't make your offsets with more than one offset a Parallel Offset.

Also please consider supporting the channel

Holmz Law Amazon wish list
https://www.amazon.com/hz/wishlist/dl/invite/aj63fks?ref_=wl_share

https://paypal.me/melrub480v?locale.x=en_US

If you have any questions or would like to stay updated follow me on

Discord - (Host live Q&A sessions) request your private link
Facebook - HolmzLaw
Reddit/HolmzLaw
Snapchat/Holmzlaw
Instagram - HolmzLaw
Twitter- Livewire480v@Holmzlaw
TikTok- HolmzLaw

#EMT#conduitology#paralleloffset