How to make or repair a clutch cable nipple.
This works also for throttle and choke cables.
It will work for a brake cable, but best advice is to fit a new cable.
It involves making a mould in wood - about 20 minutes including finding the wood.
I used a olive wood.
You will need:
Solder - I used 97% Tin 3% copper
Plumbers acid paste - tin paste without lead (containing zinc chloride)
Blow torch
Solvent - I used petrol and acetone to finish
A fine wire brush to clean the bowden cable
7.5mm drill bit (measure the original nipple)
A thick hacksaw blade
Casting the nipple only takes a few minutes.