When cutting a small board with a table saw, it is very dangerous because your finger gets close to the saw blade.
There is a push block that is pushed out when cutting a board with a jig for a table saw, and although I also use it, I was still in trouble because it was difficult to hold down small boards and I could not cut them according to the dimensions. So I made a table saw jig to cut out small parts safely and easily.
The point that I devised is that the sliding scale is fixed with a magnet, so the cutting dimensions can be easily corrected.
When the saw blade is replaced with a different thickness, the cutting position also changes, so zero correction is performed with the saw blade, but since it is only stopped by a magnet, it can be adjusted without tools.
● Related videos
[Self-made table saw cross-cut jig]
→ https://youtu.be/by-JUdYX2h8
[Table saw edge cutting jig]
→ https://youtu.be/4sMCKuD0P_Q
#DIY #table saw #safety DIY