This video is going to show you how to set up the bigtreetech S2DW and ADXL345 accelerometers on klipper. Don't worry it's super easy too.
Check out this video's sponsor PCBway - https://pcbway.com/g/08Zx0p
** Affiliate links to help the channel out **
ADXL345 V2 - https://shrsl.com/4dld9
LIS2DW (S2DW V1) - https://shrsl.com/4dldc
BTT Pi - https://shrsl.com/47lv8
All the Bigtreetech and BIQU stuff to mod your 3D printer - https://shareasale.com/r.cfm?b=1890927&u=3691202&m=118144&urllink=&afftrack=
00:00 - intro
05:12 - start the install - https://www.klipper3d.org/Measuring_Resonances.html
08:44 - configure the firmware
11:51 - compile the firmware
12:21 - connect device in boot mode.
13:23 - confirm the device is in boot mode
13:56 - flash the firmware
16:54 - get the serial for the new device
19:03 - Thank you PCBway!!!
20:17 - set-up the configuration
LIS2DW v1 - https://github.com/bigtreetech/LIS2DW/blob/master/Firmware/sample-bigtreetech-lis2dw-v1.0.cfg
ADXL345 v2 - https://github.com/bigtreetech/ADXL345/blob/cf8c1d46d98826386d575d8c14a6e0010b3d21df/Firmware/sample-bigtreetech-adxl345-v2.0.cfg
22:55 - set your axis map!
32:24 - Don't forget the the stuff you need in the printer.cfg
34:23 - confirm the sensor is up and running. ACCELEROMETER_QUERY
35:05 - install the sensor
36:43 - let's get ready to run the test
39:09 - run the auto calibrate https://www.klipper3d.org/Measuring_Resonances.html#input-shaper-auto-calibration
44:14 - SAVE_CONFIG
45:41 - what to do when you are done
46:42 - what's this Bonus??
Check out AccelFlasher - https://youtu.be/-TXBbR9szFU?si=KpriQR7W28WxHcOU